3-function garden meter - SQUARE
A device that allows you to measure both soil acidity and moisture, as well as sunlight intensity.
Very useful when growing many varieties of plants and vegetables.
Allows you to measure pH on a scale of 3 to 10.
No batteries required.
1. Set the slider to the moisture measurement position (MOIST).
2. Place the metal tip of the moisture meter in the ground, 3/4 of its height (this step should be done very gently so as not to damage the meter or the plant's roots).
3. Moisture measurement is performed using probes located on the metal tips.
4. After a while, read the value on the device's scale and compare the readings to the recommended soil moisture level for the given plant.
Measurement of soil acidity (pH):
1. Set the slider to the acidity (pH) measurement position.
2. Prepare a single sample of the soil, preferably taken from several places (300-400g), removing any stones, blades of grass, roots, leaves, etc.
3. Pour the soil into a 0.5l jar, add water to make the soil muddy.
4. Carefully wipe the meter tip with rough paper or a brush and insert the probe into the prepared substrate.
5. Take a reading after 60 seconds on the device's scale.
1. Set the slider to the sun exposure measurement position (LIGHT).
2. Sunlight values:
- low [0-500]
- neutral [500-1000]
- high [1000-2000]
1. It is recommended to thoroughly wipe the meter sensor with a cloth or paper towel immediately after the measurement.
2. The device is intended only for measuring soil moisture and pH.
3. Do not place the device directly in water or chemical solutions.
4. Plants should only be watered when the meter readings are lower than recommended. When regulating soil pH, apply any fertilizers based on the measurement results.
Udevice allowing for measuring both soil acidity and moisture, as well as solar radiation intensity.
Soil moisture measurement
Soil acidity measurement (pH)
ca. 30 cm
1. Set the slider to the sun exposure measurement position (LIGHT).
2. Sunlight values:
- low [0-500]
- neutral [500-1000]
- high [1000-2000]
soil acidity measurement |
1. Set the slider to the acidity (pH) measurement position.
2. You should prepare a one-time sample of the substrate, preferably taken in several places (300 – 400g), removing any stones, blades of grass, roots, leaves, etc.
3. Then pour the soil into a 0.5l jar, add water to make the soil muddy.
4. Carefully wipe the meter tip with rough paper or a brush and insert the probe into the prepared substrate.
5. The reading should be taken after 60 seconds on the device scale.
soil moisture measurement |
1. Set the slider to the moisture measurement position (MOIST).
2. Place the metal tip of the moisture meter in the ground, 3/4 of its height (do this very gently so as not to damage the meter or the plant's roots).
3. Moisture is measured using probes located on metal tips.
4. After a while, read the value on the device's scale and compare the readings to the recommended substrate moisture level for a given plant.
manufacturer's identification | WL-M14
No-delivery refund
