Tpms El-50448 Oec-T5 For /Gm Tire Pressure Monitoring System El50448 Tpms Reset Tool

Descriptions: Introduction : 1. The tire pressure sensor on models in & after 2012 can be read, only with some specified diagnostic tools. 2. Before tire pressure monitoring system works normally properly, the body control module will record ID information of each position in the tire pressure sensor. 3. Please refer to the specific methods as follows: Step 1 - Enter leaning mode -Set the gearshift lever to "P" -Put the ignition switch to "ON" -Enter the interface of tire pressure display by DIC -DIC shows "Press Set / Ctrl to re-learn" -Press "Set / Ctrl" -The turn signal is lighted for 3 seconds and the horn beep sound twice to enter the learning mode Step 2 - Read tire pressure sensor information -Start from the front-left wheel, -Make the J-46079 or Diagnostic Tool EL-50448 antenna up against the valve core position & close to the rim of the -tire sidewall -El-50448 tire pressure tool starts by the start switch -Successful to read the tire pressure sensor information when the horn bleeps once Step 3 - Same method to read tire pressure information Follow the instuction above to read tire pussure of the front-right, rear-right, rear-left wheels. Turn signals is lighted for 3 seconds and the horn bleeps twice when the learning is complete. Please Note : 1. For certain vehicles equipped with a Tire Pressure Monitoring (TPM) system, a "Sensor Re-Learn Procedure" must be performed after tire rotations, Remote Control Door Lock Receiver Module replacement or Tire Pressure Sensor replacement. This re-learn procedure can be performed by using special tool 50448. 2. The package does not include the charger and battery. The merchant warrants that their products comply with all applicable laws, and are offered only if they comply with Joom's policies and EU Product Safety and Compliance laws.