7m Cable Float Valve Water Level Control Switch IP68 Protection for Weak Acid Alkali Oil Pool 250V‑

Feature: 1. Use Environment: Cable float valve switch is perfect suitable for weak acid and weak alkali water or oil pool, control liquid level difference less than 40cm is not applicable. 2. Insulation Protection: Thickened cable protection sleeve makes the wire more insulated and safer to use. After multiple insulation tests, eliminating safety hazard caused by water leakage. 3. Pure Copper Wire Core: The switch adopts thickened pure copper wire core, which has good electrical conductivity and large load power, eliminating the hidden danger of heating. 4. ABS Shell: The cable float switch shell is made of preferred ABS plastic material, with good toughness, stronger, anti aging, wear resistant and durable in using. 5. 7m Cable: The automatic water level control float switch cable length is about 7m, which can meet most of the use requirements and has few restrictions on use. Specification: Item Type: Cable Float Valve Switch Material: ABS, Red Copper Use Environment: Weak acid and weak alkali water or oil pool, control liquid level difference less than approx. 40cm 15.7in is not applicable. Use Current: 15 (8A) Voltage: 250V Power Range: <1000W Product Length: Approx. 7m 23ft Maximum Operating Temperature: 70 celsius Protection Class: IP68. Package List: 1 x Float Switch1 x Hammer Note: 1. Pass the cable of the float switch through the central hole of the gravity hammer, and gently push the gravity hammer to the required specification for liquid level control. The longer the cable from the gravity hammer to the float is left. The height difference of the control liquid level is also larger.2. The gravity hammer should be fastened with the matching plastic ring. In order to prevent the gravity hammer from sliding and affecting the control of the liquid level, use a copper wire to tie the upper and lower ends.3. The cable is directly pulled to the control box, and there is no joint in the center. If there is a joint as a last resort, do not immerse the joint in the liquid.4. The unused wire ends should be wrapped with insulating tape (not included).