Product Name: Synchronous Motor
Shaft Diameter: 7mm(D-shaft: 5.5mm)
Output Shaft Length: 24mm
Torque: 0.02-1.4N.m
Model Number: TYC50
Input Voltage: AC 220V-240V 50/60Hz
Rotation Direction: CW/CCW
Power: 4W
Speed: 30-36RPM
Features:
- Low power consumption, high torque, low noise, small size, light weight, easy to use.
- Widely used for the air guide mechanism and shaking mechanism of electric fans, heaters, warm air blowers, small sun swing angles, various display stands, handicrafts, lighting fixtures, toys and other utensils, as well as the fan guide motor of various air conditioner and the turntable motor of microwave ovens.- This is a non directional synchronous motor, and will automatically inverse when encountering high resistance or load reaches the rated motor torque.
- If the motor is overloaded or stuck under load, the motor coil will not burn out.
- At rated frequency, the motor speed is not affected by voltage and remains constant.
Step diameter: 10.3mm
Step height: 3.2mm
Diameter of holes on the shaft: 3mm
Note:
- Before use, confirm that the motor voltage is correct, and if it is a DC motor, also confirm whether the power current is sufficient.
- Overloading is not allowed. The reasons for overload are mainly divided into two parts: torque and shaft force. The load torque cannot exceed the rated torque of the motor, and the shaft force cannot exceed the shaft and radial allowable force of the shaft. After adding a load, the measured current of the motor cannot exceed the rated current. Generally, the motor must be equipped with a fuse to avoid overload and burning the motor.
- Do not store or operate in high temperature or humid environments, nor do you place it in corrosive gas, as it may reduce the effectiveness of the motor.
- When assembling transmission components such as gears and pulleys on the motor shaft, do not strike them abnormally when pressing them in.
- When soldering the motor terminals of the positive and negative poles of the power supply, the soldering iron temperature should be 340 centigrade +4 centigrade, and the heating time should not exceed 3 seconds to deform the plastic. Let the soldering points flow into the motor or break the end of the wire, which will cause the motor is function to decline.
- When installing the motor, pay attention to whether the screws are too long to prevent them from colliding with the parts inside the motor.
Package Including:
1 x Synchronous Motor
The merchant warrants that their products comply with all applicable laws, and are offered only if they comply with Joom's policies and EU Product Safety and Compliance laws.
