Carmate Genuine Air Conditioner Drink Holder for Toyota Corolla No Tools Required for NZ829 Cross, Driver's Side, Installation,

[Drink holder exclusively for the driver's seat of the Toyota Corolla Cross] This drink holder is designed and made exclusively for the driver's seat of the right-hand drive Corolla Cross (from September 2021 (Reiwa 3)). Since it is designed exclusively for the Corolla Cross, the resin used is also color-matched to the interior color of the Corolla Cross. The body has a surface design that matches the interior of the Corolla Cross, and the top frame matches the color of the air conditioning vent (excluding special edition vehicles, etc.). [Specially designed to not interfere with the turn signal lever] A typical drink holder that is attached to an air conditioner outlet may not be able to be installed because the main body interferes with the turn signal lever on the driver's seat, but this product is specially designed for the Corolla Cross so that it does not interfere with the turn signal lever and can be installed on the air conditioner outlet. Because it is specially designed, it can be installed in the best position, and even if you change the steering position or operate the turn signal lever, it will not interfere and will not interfere with driving. [Adjustable air conditioner direction] Because it is installed in the vehicle without using air conditioner fins, unlike general air conditioner-mounted drink holders, the direction of the air conditioner fins can be adjusted. By providing an air conditioner fin operation port on the top of the drink holder, it is designed to make it easy to operate the air conditioner fins. In addition, the air conditioner's wind can keep drinks hot or cold. [Can hold drinks of various sizes] Compatible with drink containers with a diameter or diagonal length of 53 to 74 mm when viewed from above. (For cafe cups and chilled cups that expand from the bottom to the top, the size at the position 79 mm from the bottom must be 74 mm or less.) In addition, there is a flap on the inside of the holder so that it can hold thin cans. [Sponge cushion included] The bottom of the drink holder is equipped with a sponge cushion to prevent drinks from rattling and rattling while driving. * Although the cushion is made of sponge material, it is not absorbent to absorb condensation or spilled drinks. [Easy installation without tools (estimated installation time: 8 minutes)] Insert the included mounting base into the gap of the air conditioner outlet and attach the main unit. Since no tools are required, it can be easily installed. In addition, it is specially designed so that it can be installed without scratching the interior or leaving any installation marks.