Feature:
1. CONTROLLABLE TEMPERATURE: The water flow temperature of this water heater is between 20 celsius and 50 celsius , the temperature is low for large water flow and high for small water flow.
2. SWITCHABLE UNIT: The water heater can be set in Fahrenheit and Celsius mode, and the mode can be switched by pressing and holding the on button for more than 6 seconds when the power is on.
3. WATER HEATER: This water heater has a power of 3500W, a stainless steel heating body, and a frequency of 50 to 60Hz for stable performance.
4. MAIN APPLICATION: This water heater is suitable for installation in kitchens, toilets, showers, public bathrooms and other places where washing up, washing hands and dishes are normally done.
5. EASY INSTALLATION: This water heater is small, heats quickly, and saves time and effort with easy and convenient installation steps.
Specification:
Item Type: Instant Hot Water Heater
Material: ABS, copper, stainless steel
Power: 3500W
Heating Body: Stainless steel
Frequency: 50-60HZ
Electric Wire: 1.5mm2
Temperature Range: 20-50 celsius
Installation Environment Requirements: kitchen, bathroom, toilet, shower room, wire requirements greater than 2.5mm2, circuit breaker switch greater than 32A
Weight: Approx. 1100g / 38.8ozping.
Package List:
1 x Instant Hot Water Heater2 x Screw2 x Expansion Tube1 x Instruction
Note:
Common failures and treatment methods: 1 . Check whether the power supply is normally energized, energized display will light up to show the temperature, not energized will not light up.2. Normal power supply, water flow open, press the on/off button, the machine starts heating, water heater display: water temperature 3. If the temperature does not rise, there are 2 possibilities: one is the water heater internal temperature control switch (overheat protection switch) jump, press the temperature control switch, you can restore. The other is a heating tube failure, replace the heat pipe can4. If there is no heating display, the display runner lights turn circle, indicating that the water does not pass through the water heater, or water pressure is too low, or the installation of the wrong direction, pay attention to the water inlet and outlet to install the correct, but if the water pressure is enough, there is water flow is not heated, then check the water heater inlet, there may be something dirty stuck, resulting in the water heater does not start.5. water heater outlet pipe length is recommended not to exceed 3 meters, if beyond the long water pipe may to a water pressure difference, water pressure is not enough to start. (If the use of water towers in rural areas, the height of the water tower is required to be higher than 10 meters, so that the water pressure to start value)6. Display shows E1 over temperature, E3/E4 or temperature sensor failure, first power off, with cold water over the machine, and then in the power to use, pay attention to the usual use of water flow is not too small7. Heating tube failure display E2, the need to replace the heating tube
No-delivery refund
