Feature:
1. The structure is simple, the product is relatively easy to assemble, and no time is wasted.
2. Made of high‑quality plastic, it has good stability and good safety performance.
3. It adopts continuous mode, easy and stable, which is very practical.
4. laser , which can completely replace the old or broken , very convenient.
5. Built to strict quality control standards, design improved for high quality and good performance.
Specification:
Item Type: Laser
Material: Plastic
Model: VAM-1202
Purpose: Radio CD player laser lens optical
Band Range: Visible light
Mode: Continuous
Incentive : Electrical excitation
Working Substance: electrons
Light Path: Inner light path
Output Form: Power type
: OC gate type
Speed: Low speed
Channel: Single channel
Output Wavelength: 650 (nm)
Line Width: Approx. 1mm/0.04in
Laser installation knowledge:
1. How to judge the damage of the laser : The damage of the laser generally means that it does not read the disc or it is very difficult to read the disc. Some discs with poor quality cannot be read at all. When the device can normally recognize the machine, it is usually a laser . When the situation occurs, you only need to disassemble the laser to check the model of the laser , and then buy the corresponding model of bald and install it, and the machine can be restored as new.
2. How to judge the model of the laser : Generally, there is a model on the label of the laser or on the base. If not, you can take the picture of the bald and send it to us, and we will have professional technicians to confirm the model for you . Please confirm the model of the laser you need before purchasing, so as to avoid accidental shooting.
3. How to install the laser : When installing the laser on the shelf, do not move the balance bar on the shelf. When disassembling the laser , you only need to adjust screw of the balance bar on side, and do not adjust the other side, so as not to affect the balance, otherwise the laser may not read the disc. If you can’t install it yourself, you can ask a professional to test the installation after purchase to avoid damage to the laser and the machine.
4. How to open the solder joints: When the laser is shipped from the factory, in order to prevent static electricity from damaging the laser tube, there are generally protective solder joints (a larger solder joint on the bald circuit board or on the flexible cable). The power supply pin of the laser tube is short-circuited to the ground. Before installing the bald , it needs to be welded with an anti-static soldering iron. Heat the soldering iron to about 250℃-280℃, disconnect the power supply, and then open the protective point, otherwise the laser Will be unavailable.
Package List:
1 x Laser
No-delivery refund
