High Quality 2.5cm*5M 10M 15M Titanium/Black Exhaust Heat Wrap Roll for Motorcycle Fiberglass Heat Shield Tape with Stainless Ties

Application:

Universal(For Header, Turbo manifold, Downpipe, Motorcycle piping). Vehicle compatibility charts are for REFERENCE ONLY. Check your vehicle with OEM below to match your needs.

Specification: 100% quality assurance tested, more responsive, less expensive, easier to install. Withstand direct heat up to 1652°F(900°C). Pre-wetting roll not necessary for wrapping. Optimizes horsepower, performance and fuel economy. Reduces underhood temperatures and maintains high exhaust gas velocity.

Material & Color: Material: made of high qualityBasalt Fiber. Color: as picture.

Package Included: 1x Heat Wrap; 4x 200mm Locking Tie.(100% Brand New Never Used Or Installed)

Note: 1.       Fold 3/4” at the edge of the exhaust wrap, tuck the 3/4” fold under the exhaust wrap, and place on the pipe. This reduces fraying on the end of the wrap. 2.       Make one full initial wrap around the pipe, roughly around pipe 3 to 4 more times, secure wrap at flange with locking tie. 3.       After securing end, continue to wrap around pipe, using 1/4” overlap with each pass, and keeping tension on the exhaust wrap. 4.       If primary tubes become so close together, wrap multiple pipes as one. If bend less than 90°, add approximately 8” of wrap; if bend greater than 90°, add approximately 14” of wrap. And maintain the same 1/4” overlap. 5.       On the final pass around the pipe, fold over about 3/4” of the wrap, and tuck it underneath itself. Then secure the last coil of wrap with locking tie.