Label:Yes
Used for various electronic soldering and tin suction.
Can be used to replace integrated circuits, multi-pin switches, etc.
It is convenient to clear the components to be replaced from the board without damaging the components and the board.
This tin can be used as a electric soldering iron. It is an indispensable tool for national defense, scientific research, communication, aerospace, computer,television, electronic professional maintenance personnel and the majority of enthu
Medium size is easy to hold and good for one-hand use.
Specification:
Material: Plastic Handle + Stainless Steel Tube
Power: 30W
Temperature Adjustment Range: 400°C
Color:Blue and Black
Size :As picture shown
Package List:
1 * Soldering Iron
1 * Nozzle
1 * PCB Needle
Note:
1. The real color of the item may be slightly different from the pictures shown on the website caused by many factors such as brightness of your monitor and light brightness.
2. Please allow slight manual measurement deviation for the data. Thank for your understanding.
3. 1cm=0.39''.
Instructions:
1. Turn on the power and warm up for 3-5 minutes.
2. Push the piston handle down and the front end of the suction soldering iron nozzle is aligned with the solder joint of the component to be take off. After the solder is melted, press the control button, and the solder is sucked into the intake cylinder.
3. The suction device is equipped with two nozzles with different diameters, which can be selected according to the thickness of the component leads.
4. When welding, the same use as using an electric soldering iron
5. When disassembling the air cylinder, press the upper end of the air cylinder downward according to the marked direction. When the air cylinder and the handle are pulled apart, the air cylinder can be separated. When the suction nozzle is take off, the suction nozzle is rotated counterclockwise to the suction nozzle. Removal considerations
7. Before use, tighten the suction nozzle and the air cylinder to avert air leakage, otherwise it will affect the tin absorption effect.
8. Frequently clear the solder impurities entering the nozzle and the gas cylinder, and add a little oil to the piston.
9. After each use, push the piston 3-4 times to clear the leftover solder in the straw, so that the nozzle and the straw are unblocked for the next use.
10. After the suction device is energized, it is strictly forbidden to install and disassemble its electric parts.
11. When the new soldering device is used for the first time, it may be slightly smoked due to the heating of the inernal part. This is a normal phenomenon and will disappear after ten minutes.
12. During use, the soldering iron seat with passive cooling structure must be used and should be placed in the soldering iron base.
13. If the power cord is damaged, it must be replaced by the manufacturer or its maintenance department or a similar professional to avoid danger.
14. This product has a ground wire, it should be used with a socket with contacts, please pay attention to the use, in order to safety
No-delivery refund
